RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
1. Position the front outboard seat belt and retractor (7) to the inner B-pillar as a unit. Be certain to engage the tab on the upper retractor bracket into
the hole in the B-pillar.
2. Loosely install the screw (6) that secures the lower retractor bracket to the B-pillar.
3. Install and tighten the screw (4) that secures the upper retractor bracket to the B-pillar. Tighten the screw to 12 Nm (105 in. lbs.).
4. Tighten the screw that secures the lower retractor bracket to the B-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
5. Position the belt web guide (1) to the B-pillar and use hand pressure to press it firmly and evenly until the two clips that secure it snap into place.
6. On light-duty DR 1500 only, reconnect the yellow body wire harness connector (5) to the seat belt tensioner initiator on the retractor.
7. Reinstall the lower trim (3) onto the inside of the B-pillar. Be certain that the turning loop (2) can be accessed from the face of the lower trim after
the seat belt webbing is inserted through the slot in the trim. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim .
8. Reinstall the upper trim (2) onto the inside of the B-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim .
9. Position the seat belt turning loop (5) onto the height adjuster (1) on the upper B-pillar.
10. Install and tighten the screw (4) that secures the turning loop to the height adjuster. Tighten the screw to 39 Nm (29 ft. lbs.).
11. Engage the upper edge of a new trim cover (3) over the top of the turning loop. Then squeeze the lower end of the trim cover and the turning loop
together firmly and evenly until the engagement tabs of the trim cover snap into the slots of the turning loop.
