RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
Hood Sensor/Switch (For Alarm): Service and Repair
Hood Ajar Switch - Installation
SWITCH
1. Position the hood ajar switch (2) near the hole in the mounting bracket (3) on the right front load beam (6).
2. Route the jumper wire harness connector (5) through the switch mounting bracket and reconnect it to the switch connector receptacle.
3. From the top of the mounting bracket, press the switch downward into the mounting hole until the integral switch latch tabs lock it into place.
4. Reconnect the battery negative cable.
5. Close and latch the hood.
