RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
Power Seat Switch: Service and Repair
Power Seat Switch - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the seat cushion side shield from the seat.
3. Pull the switch bezel or side shield unit (1) out from the seat far enough to access the switch wire harness connector. Gently pry the locking tabs of
the switch away from the wire harness connector and carefully unplug the connector from the power seat switch module (2).
4. Remove the screws (3) that secure the power seat switch (2) to the side shield unit (1).
