RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
a. Loosen both drag link adjuster sleeve clamp nuts (Figure 7).
b. Remove and discard the inner drag link joint to pitman arm nut (Figure 7).
c. Use Special Tool C-4150A to separate the steering inner drag link joint from the pitman arm (Figure 8).
d. While counting the number of turns, unscrew the steering inner drag link joint from the drag link adjuster sleeve (right handed threads) and
discard the drag link inner joint.
CAUTION:
Do not allow the drag link adjuster sleeve to turn while unscrewing the inner drag link joint.
e. Screw in the new inner drag link joint into the drag link adjuster sleeve the same number of turns counted in step 6d. of this procedure.
f. Connect the steering inner drag link joint to the pitman arm.
g. Install the new steering inner drag link joint nut and tighten the nut to 100 ft. lbs. (135 N.m).
