RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
CAUTION: When installing puller 8677 to separate the ball joint, be careful not to damage the ball joint seal.
7. Remove the lower ball joint nut. Separate the ball joint from the knuckle with Remover 8677 (2).
8. Remove the steering knuckle (1) from the vehicle.
9. Remove the hub/bearing from the steering knuckle on the bench See: Suspension/Wheel Bearing/Service and Repair/Front Hub / Bearing -
Removal .
(HD) 4X2 - Independent Front Suspension
(HD) 4X2
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Remove the brake caliper, rotor See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Removal, shield and ABS wheel speed sensor if equipped See: Brakes and Traction Control/Antilock Brakes /
Traction Control Systems/Wheel Speed Sensor/Service and Repair/Front Wheel Speed Sensor - Removal .
4. Remove the tie rod end nut. Separate the tie rod from the knuckle with Remover 9360.
5. Remove the upper ball joint nut. Separate the ball joint from the knuckle with Remover 9360.
