RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
9. Perform a wheel alignment See: Alignment/Service and Repair .
2500 & 3500 - 4WD - Link/Coil
2500 & 3500 - 4WD
1. Position the steering knuckle on the ball studs.
2. Install and tighten lower ball stud nut to 47 Nm (35 ft. lbs.) torque.
3. Install and tighten upper ball stud nut to 94 Nm (70 ft. lbs.) torque.
4. Retorque lower ball stud nut to 200 Nm (148 ft. lbs.) torque.
5. Install the hub bearing See: Suspension/Wheel Bearing/Service and Repair/Front Hub / Bearing - Installation .
6. Install tie-rod or drag link end onto the steering knuckle arm.
7. Install the wheel speed sensor. See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed Sensor/Service and
Repair/Front Wheel Speed Sensor - Installation .
4500 & 5500 - Link/Coil
4500 & 5500
1. Position the steering knuckle (1) on the ball stud.
2. Install and tighten lower ball stud nut (3) to 47 Nm (35 ft. lbs.) torque.
3. Install the upper ball joint (2) into the steering knuckle Tighten to make sure the wheel speed sensor bracket (3) for the wire is installed
between the knuckle and ball joint (2).
4. Install and tighten upper ball stud nut (1) to 94 Nm (70 ft. lbs.) torque.
5. Retorque lower ball stud nut to 200 Nm (148 ft. lbs.) torque.
