RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
Steering Shaft Coupler: Service and Repair
Steering Coupling - Installation
Upper Coupling
INSTALLATION
1. Install the upper steering coupling shaft (3) to the vehicle.
2. Install the upper steering coupling shaft seal (2) by pushing it in securing the four tangs (1) to the panel.
NOTE: A new steering coupling shaft pinch bolt for the upper and lower shafts must be used.
3. Install the steering coupler shaft (1) to the column.
4. Install the upper pinch bolt (3) use new bolt and tighten to 57 N.m (42 ft.lbs).
5. Install the shaft to the lower coupler (1).
6. Install the lower pinch bolt (1) use new bolt and tighten to 57 N.m (42 ft.lbs).
7. Unlock the steering wheel.
8. Reconnect the negative battery cable.
Lower Coupling - All LD & HD Except 4X4 HD
