RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
2. Align the front of the spring with the bolt hole in the front bracket. Install the eye pivot bolt and nut (4).
3. Align the rear of the spring (1) into the shackle (3) and install the bolt and nut (2).
4. Tighten the spring front and rear eye pivot bolt snug, Do not torque.
5. Install the spring clamp bolts (1), plate (3) and the retaining nuts (2).
6. Remove the holding fixture for the rear axle.
7. Remove the supports and lower the vehicle so that the weight is being supported by the tires.
8. Tighten the spring clamp retaining nuts (3) to 149 Nm (110 ft. lbs.).
9. Tighten the spring front and rear pivot bolt nuts to 163 Nm (120 ft. lbs.)(LD) or 230 Nm (170 ft. lbs.)(HD).
Removal
REMOVAL
1. Raise and support the vehicle.
2. Remove both rear tire and wheel assemblies
