RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
Wheel Bearing: Service and Repair
Front Hub / Bearing - Installation
4X2 - Independent Front Suspension
4X2
1. Install the brake dust shield (2).
2. Install the hub/bearing (1) into the steering knuckle (3) and tighten the bolts (5) to 163 Nm (120 ft. lbs.) 4X2 LD. Or tighten the bolts (5) to 176
Nm (130 ft. lbs.) 4X2 HD..
3. Install the brake rotor and caliper See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Installation .
4. Install the ABS wheel speed sensor if equipped (4) See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed
Sensor/Service and Repair/Front Wheel Speed Sensor - Installation .
5. Install the wheel and tire assembly See: Service and Repair/Removal and Replacement .
6. Remove the support and lower vehicle.
2500 & 3500 - 4WD - Link/Coil
2500 & 3500 - 4WD
1. Position the brake shield (1) on bolts.
2. Install the hub/bearing to the knuckle. Tighten the hub/bearing bolts (2) to 202 Nm (149 ft. lbs.
3. Install the hub nut and tighten to 356 Nm (263 ft. lbs.).
4. Install the wheel speed sensor to the hub. See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed
Sensor/Service and Repair/Front Wheel Speed Sensor - Installation .
5. Install the disc brake rotor. See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Installation .
6. Install the brake caliper adapter with the caliper, See: Brakes and Traction Control/Disc Brake System/Brake Caliper/Service and Repair/Removal
and Replacement/Disc Brake Caliper Adapter - Installation .
