RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
12. Install the TRS selector plate (1) onto the valve body and the manual valve.
13. Position the detent spring (2) onto the valve body.
14. Install the screw to hold the detent spring (2) onto the valve body. Tighten the screw to 4.5 Nm (40 in. lbs.).
15. Install new clutch passage seals (3) onto the valve body, if necessary.
16. Install the solenoid and pressure switch assembly onto the valve body.
17. Install the bolts (1) to hold the solenoid and pressure switch assembly onto the valve body. Tighten the bolts to 6 Nm (50 in. lbs.). Tighten the
bolts adjacent to the arrows cast into the bottom of the transfer plate first.
Disassembly
DISASSEMBLY
CAUTION: Do not clamp any valve body component in a vise. This practice can damage the component resulting in unsatisfactory operation
after assembly and installation. Do not use pliers to remove any of the valves, plugs or springs and do not force any of the components out or
into place. The valves and valve body housings will be damaged if force is used. Tag or mark the valve body springs for reference as they are
removed. Do not allow them to become intermixed.
