RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
Clutch Disc: Adjustments
PRESSURE PLATE DIAPHRAGM SPRINGS
NOTE:Perform the following procedure, when replacing only the clutch disc on Diesel vehicles with Dual Mass Flywheel and self- adjusting
pressure plate. The pressure plate must be reset before installing a new disc.
1. Support pressure plate flange with press blocks (3) on a press.
2. Center press ram (2) on the pressure plate diaphragm spring fingers (1).
3. Compress the diaphragm spring fingers (1), until tension is released from the stepped adjusting ring.
4. Place two screwdrivers against two of the three stepped adjusting ring (1) tension spring stops, just ahead of the adjusting ring tension springs on
the pressure plate (2).
