RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
9. Grasp protruding bearing cap with vise jaws and tap link yoke with a mallet to remove bearing cap.
10. Flip assembly and repeat STEP 6, STEP 7, STEP 8 and STEP 9 to remove the opposite bearing cap.
11. Remove cross centering kit assembly and spring.
12. Press remaining bearing caps out the other end of the link yoke.
Assembly
ASSEMBLY
CAUTION: All alignment marks on the link yoke and propeller shaft yoke must be aligned during assembled.
1. Apply (EP) N.L.G.I. Grade 1 or 2 grease to inside of yoke bores.