RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
Windshield Washer Pump: Service and Repair
Removal
Diesel Engine
DIESEL ENGINE
NOTE: The washer pump/motor unit can be removed from the washer reservoir without removing the reservoir from the vehicle.
1. Disconnect and isolate the battery negative cable.
2. Disconnect the washer hose from the barbed outlet nipple (8) of the washer pump/motor unit and allow the washer fluid to drain into a clean
container for reuse.
3. Disconnect the left headlamp and dash wire harness connector from the washer pump/motor unit connector receptacle (1).
4. Firmly grasp the top of the washer pump/motor housing.
5. Pull lightly outward on the top of the washer pump/motor housing, away from the washer reservoir (6) far enough to disengage the snap post (2)
on the top of the motor from the receptacle (3) in the reservoir.
6. Pull the washer pump/motor unit straight out from the washer reservoir far enough to disengage the barbed pump inlet nipple (7) from the rubber
grommet seal (4) in the reservoir.
7. Remove the washer pump/motor unit from behind the washer reservoir.
8. Remove the rubber grommet seal from the pump mounting hole in the reservoir and discard.
Gasoline Engine
GASOLINE ENGINE
NOTE: The washer pump/motor unit can be removed from the washer reservoir without removing the reservoir from the vehicle.
1. Disconnect and isolate the battery negative cable.
2. Disconnect the washer hose from the barbed outlet nipple (8) of the washer pump/motor unit and allow the washer fluid to drain into a clean
container for reuse.
