RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo (2008)
3. Disconnect the right headlamp and dash wire harness connector from the washer pump/motor unit connector receptacle (1).
4. Firmly grasp the top of the washer pump/motor housing.
5. Pull lightly outward on the top of the washer pump/motor housing, away from the washer reservoir (6) far enough to disengage the snap post (2)
on the top of the motor from the receptacle (3) in the reservoir.
6. Pull the washer pump/motor unit straight out from the washer reservoir far enough to disengage the barbed pump inlet nipple (7) from the rubber
grommet seal (4) in the reservoir.
7. Remove the washer pump/motor unit from behind the washer reservoir.
8. Remove the rubber grommet seal from the washer pump mounting hole in the reservoir and discard.
