RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
3. Move the load floor (3) to the down position and install the two nuts (2) that secure the load floor to the floor panel. Tighten the nuts to 25 Nm (18
ft. lbs.).
4. Move the rear seat cushion (1) to the down position.
Removal
REMOVAL
REGULAR CAB
1. Remove the cowl trim panel.
2. Remove the upper B-pillar trim panel.
3. Remove the bolt (2) that secures the seat belt (1) to the bottom of the B-pillar (4) and position the seat belt out of the way.
4. Using a trim stick C-4755 or equivalent, disengage the retaining tabs that secure the lower B-pillar trim panel (3) to the B-pillar.
5. Remove the seat belt from the lower B-pillar trim panel through the slot provided and remove the trim panel.
QUAD CAB
