RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
1. Install the seat cushion and cover over the cushion frame assembly and connect the zip strip.
2. Install the seat.
Removal
REMOVAL
1. Remove the seat cushion/cover.
2. Remove the bolts (3) and remove the seat cushion frame (2).
Installation
INSTALLATION
1. Install the seat cushion frame (2) onto the rear seat cushion hinges (4).
2. Install the bolts (3) and tighten to 85 Nm (63 ft. lbs.).
3. Install the seat cushion/cover.
Removal
REMOVAL
1. Fold both rear seats flat.
2. Remove the filler panels from the rear seat to storage compartment.
3. Separate the J-straps at the bottom of the seat back.
4. Remove both hinge covers from the back section being worked on.
5. Remove the lower anchor for the center seat belt.
6. Disconnect the lower cable attachment from the seat back release.
