RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
Cruise Control Servo: Service and Repair
Installation
INSTALLATION
A speed control servo is used only with the 4.7L V-8 engine.
1. Position servo to mounting bracket .
2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip .
3. Insert servo mounting studs through holes in servo mounting bracket.
4. Install 2 servo-to-mounting bracket nuts and tighten to 60 in. lbs. (7 Nm).
5. Position servo assembly to correct mounting lugs on battery tray and install 3 screws. Tighten to 30 in. lbs. (4 Nm).
6. Connect vacuum line at servo.
7. Connect electrical connector at servo.
8. Connect servo cable to throttle body.
9. Install left-front wheel-well liner.
10. Connect negative battery cable to battery (connect both cables if diesel).
11. Before starting engine, operate accelerator pedal to check for any binding.
