RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
CAUTION: Always use the retaining screws supplied with the replacement air outlet. Do not use screws longer then 10 mm. Failure to
follow this caution may result in damage to the instrument panel cover.
CAUTION: Use care when installing the air outlet retaining screws. To prevent damage to the instrument panel cover, do not
overtighten the screws.
2. Install six M 4.2 x 9.5 mm screws (1) to secure the air outlet assembly to the instrument panel cover. Carefully tighten the screws securely.
3. Install the instrument panel cover.
4. Install the instrument panel.
Installation-Rear Seat Air Outlets
INSTALLATION-REAR SEAT AIR OUTLETS
NOTE: The air outlets are retained into the air outlet housing by eight retaining tabs. The air outlets must be first installed onto the bottom set of
retaining tabs, then the upper set of tabs can be engaged.
1. Position the rear air outlets (1) to the back of the rear air outlet housing (2) and engage the lower set of retaining tabs (3).
2. Gently engage the upper set of retaining tabs (4). Make sure all of the retaining tabs are fully seated.
NOTE: Illustration shown with front seat cushions removed for clarity.
3. Position the rear air outlet housing (2) to the rear of the front center seat support (3).
4. Install the two screws (1) that secure the rear air outlet housing to the center seat support. Tighten the screws to 2.2 Nm (20 in. lbs.).
