RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
10. Install the instrument panel assembly See: Body and Frame/Interior Moulding / Trim
11. Install the two nuts (3) that secure the HVAC housing (1) to the engine compartment side of the dash panel (2). Tighten the nuts to 6.8 N.m (60 in.
lbs.).
12. Install the Powertrain Control Module See: Powertrain Management/Computers and Control Systems/Engine Control Module
13. Connect the heater hoses to the heater core tubes.
14. Reconnect the negative battery cable.
15. Refill the engine cooling system See: Engine, Cooling and Exhaust/Cooling System
16. Initiate the Actuator Calibration function using a scan tool See: Testing and Inspection
Air Inlet Housing Installation
AIR INLET HOUSING
NOTE: The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.
NOTE: If the foam seal on the air inlet housing is deformed or damaged, it must be replaced.
1. Position the air inlet housing (2) onto the top of the HVAC housing (3).
2. Engage the two retaining clips (1) that secure the front of the air inlet housing to the HVAC housing.
