RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
26. Install the air inlet housing (3) onto the top of the HVAC housing (4).
27. Install the HVAC wire harness (1) onto the HVAC housing. Make sure the wires are routed through all wiring retainers.
28. Install the evaporator temperature sensor (2) into the opening in the top of the HVAC housing. Make sure the sensor is fully engage to the housing.
29. Connect the HVAC wire harness to the evaporator temperature sensor.
30. Position the blower motor resistor (7) and the blower motor (2) into the bottom of the HVAC housing (5).
31. Install the screws (4) that secure the blower motor to the HVAC housing. Tighten the screws to 1.7 Nm (15 in. lbs.).
32. Install the screws (6) that secure the blower motor resistor to the HVAC housing. Tighten the screws to 1.1 Nm (10 in. lbs.).
33. Connect the HVAC wire harness connectors (1 and 3) to blower motor resistor and the blower motor.
