RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
3. Use a small thin-bladed screwdriver to rotate the bulb holder (3) counterclockwise about 30 degrees to unlock it from the keyed opening in the
Electronic Vehicle Information Center (EVIC) unit (2) circuit board.
4. Pull the bulb holder and bulb straight out of the circuit board.
Electronic Vehicle Information Center
ELECTRONIC VEHICLE INFORMATION CENTER
NOTE: If a new Electronic Vehicle Information Center (EVIC) has been installed, the compass will have to be calibrated and the variance set.
1. Position the EVIC (3) onto the overhead console housing (1).
2. Install the screws (2) that secure the EVIC (3) to the overhead console housing (1). Tighten the screws to 2 Nm (20 in. lbs.).
3. Install the overhead console (1) onto the headliner.
4. Reconnect the battery negative cable.
Bulb - EVIC Control
BULB - EVIC CONTROL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: There are provisions for up to four bulb/bulb holder units on the Electronic Vehicle Information Center (EVIC) circuit board. The two outboard
bulbs illuminate the EVIC push buttons, while the two center bulbs illuminate the optional universal transmitter push buttons. Therefore, the center bulb
locations are only populated on vehicles equipped with the optional universal transmitter.
