RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
Turn Signal Bulb: Service and Repair
Lamp-Tail/Stop/Turn
Bulb - Cab And Chassis
BULB - CAB AND CHASSIS
NOTE: The rear lamp unit contains two bulbs: the park/turn signal/brake/license plate, and the backup. The service procedures for each bulb are the
same, only the bulb sizes and types may differ.
1. Disconnect and isolate the battery negative cable.
2. Remove the four screws (1) that secure the lens (2) to the rear lamp unit housing (5).
3. Push the backup lamp bulb (4), or the park/turn signal/brake/license plate bulb (7) slightly into its socket (3) or (6), then rotate the bulb
counterclockwise about 30 degrees to unlock it.
4. Pull the base of the bulb straight out of the socket.
Bulb - Pick-Up
BULB - PICK-UP
NOTE: The rear lamp unit contains two bulbs: park/stop/turn signal/side marker and backup. The service procedures for each bulb are the same, only
the bulb sizes and types may differ.
1. Disconnect and isolate the battery negative cable.
2. Remove the rear lamp unit (1) from the end of the quarter panel.
