RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
6. Engage the A/C liquid line (1) into the three body retaining clips (2 and 3) located at the right front corner of the engine compartment.
7. Lubricate a new O-ring with clean refrigerant oil and install it and a new gasket onto the front liquid line fitting. Use only the specified O-ring seal
as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
8. Connect the front section of the A/C liquid line (2) to the condenser port.
9. Install the nut (1) that secures the A/C liquid line to the A/C condenser (3). Tighten the nut to 23 Nm (17 ft. lbs.).
10. Position the air seal over the right end of the A/C condenser and install the air seal retainers.
11. Install the passenger side battery tray.
12. Reconnect the negative battery cable(s).
13. Evacuate the refrigerant system.
14. Adjust the refrigerant oil level.
15. Charge the refrigerant system.
REAR SECTION
