RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
13.
Highlight the listed calibration.
14.
Select "Update Controller". Follow on screen instructions.
15.
When the CCN update is complete, select "OK".
16.
Verify the part number at the top of the "Flash CCN" screen has updated to the new part number.
NOTE:
Due to the CCN programming procedure, a DTC may be set in other modules (PCM, TCM, BCM, MIC, SKREEM, etc.) within the vehicle, if so
equipped. Some DTC's may cause the MIL to illuminate. From the "Home" screen select "System View". Then select "All DTCs". Press "Clear All
Stored DTCs" if there are any DTCs shown on the list.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
