RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
1. Position the front center seat belt and retractor unit (5) to the floor panel (6) at the base of the cab back panel (8) to the right of center.
2. Install and tighten the two screws (4) that secure the front center seat belt retractor bracket to the floor panel near the base of the cab back panel.
Tighten the screws to 40 Nm (29 ft. lbs.).
3. Position the belt bracket (2) of the front center seat belt (7) to the body bracket (1) on the upper cab back panel reinforcement.
4. Install and tighten the two screws (3) that secure the belt bracket of the front center seat belt to the body bracket on the upper cab back panel
reinforcement. Tighten the screws to 20 Nm (15 ft. lbs.).
5. Reinstall the trim (1) onto the cab back panel.
6. Route the webbing of the front center seat belt (4) through the bezel (5) and position the bezel to the belt opening near the top of the cab back trim
panel.
7. Using hand pressure, press firmly and evenly on each side of the front center seat belt bezel until it snaps into place on the cab back trim panel.
8. Reinstall the stowage tray onto the rear floor panel behind the seat.
9. Reach between the center of the front seat cushion and front seat back to access and buckle the front center seat belt lower anchor latch plate to the
unique black, keyed lower anchor buckle.
Front Outboard - Quad And Mega Cab
FRONT OUTBOARD - QUAD AND MEGA CAB
