RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
CAUTION: When installing puller 8677 to separate the ball joint, be careful not to damage the ball joint seal.
7. Remove the lower ball joint nut. Separate the ball joint from the knuckle with Remover 8677 (2).
8. Remove the steering knuckle (1) from the vehicle.
9. Remove the hub/bearing from the steering knuckle on the bench.
(HD) 4X2
(HD) 4X2
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Remove the brake caliper, rotor, shield and ABS wheel speed sensor if equipped.
4. Remove the tie rod end nut. Separate the tie rod from the knuckle with Remover 9360.
5. Remove the upper ball joint nut. Separate the ball joint from the knuckle with Remover 9360.
CAUTION: When installing puller 8677 to separate the ball joint, be careful not to damage the ball joint seal.
6. Remove the lower ball joint nut. Separate the ball joint from the knuckle with puller 8677 and remove the knuckle.
7. Remove the hub/bearing from the steering knuckle.
(LD) 4X2 & 4X4
(LD) 4X2 & 4X4
