RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
7. Remove the steering knuckle.
8. Remove the stabilizer link.
9. Remove the lower control arm support.
10. Tighten the spring compressor tool (2) to collapse the coil spring.
NOTE: It may necessary to loosen the control arm pivot bolt to allow downward swing.
11. Loosen the tension on the spring compressor tool (2) slowly allowing the lower suspension arm to pivot downward.
12. Remove the spring compressor tool (2).
13. Remove coil spring (1) and isolator pad from the vehicle.
Installation
4X2
1. Tape the isolator pad to the top of the coil spring. Position the spring in the lower suspension arm well. Be sure that the coil spring is seated in the
well.
2. Install Spring Compressor DD-1278 (2) up through the lower suspension arm, coil spring and shock hole in the frame.
3. Tighten the tool nut to compress the coil spring.
