RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
Wheel Bearing: Service and Repair
Front - Link/Coil
Removal
REMOVAL
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Remove the hub extension (1) mounting nuts and remove the extension from the rotor if equipped.
4. Remove the brake caliper.
5. Remove the cotter pin (2) and the hub nut (1) from the axle shaft.
6. Remove the caliper adapter.
7. Remove the disc brake rotor.
8. Disconnect the wheel speed sensor wire.
9. Remove the hub/bearing 4 mounting bolts and remove the hub/bearing.
Installation
INSTALLATION