RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
Rear Door Window Regulator: Service and Repair
Window Regulator - Manual
Removal
REMOVAL
1. Remove the inner belt molding.
2. Remove the waterdam.
3. Reinstall the manual window crank and raise the door glass to the position shown.
4. Remove the two nuts (1) that secure the door glass (2) to the window regulator (3) through the speaker opening (5) and the sight window (4) and
disengage the door glass from the regulator.
5. Position the door glass to the full up position and secure the glass using a wooden wedge or an equivalent.
6. Lower the window regulator (5) and remove the two nuts (3) that secure the regulator stabilizer (4) to the door (1).
7. Remove the two bolts (2) that secure the window regulator to the door and loosen the other two regulator bolts (6).
8. Slide the window regulator upward and disengage the two regulator bolts from the door.
9. Remove the window regulator through the opening in the door.
Installation
INSTALLATION