RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo (2008)
Rear Door Window Regulator: Service and Repair
Rear Door Window Regulator - Removal
Power
REMOVAL
1. Remove the inner belt molding See: Rear Door Window Glass/Rear Door Window Glass Weatherstrip/Service and Repair/Rear Door Inner Belt
Molding/Removal .
2. Remove the waterdam See: Rear Door Panel/Service and Repair/Rear Door Waterdam/Removal .
3. Remove the electric window switch from the door trim panel and connect it to the door wire harness See: Sensors and Switches/Sensors and
Switches - Windows and Glass/Power Window Switch/Service and Repair/Removal .
4. Raise the door glass to the position shown.
5. Remove the two nuts (1) that secure the door glass (2) to the window regulator (3) through the speaker opening (5) and the sight window (4) and
disengage the door glass from the regulator.
6. Position the door glass to the full up position and secure the glass using a wooden wedge or an equivalent.
7. Lower the window regulator and remove the two nuts (1) that secure the regulator stabilizer to the door.
8. Remove the bolts (2) that secures the window regulator to the door and loosen the other two regulator bolts (3).
9. Slide the window regulator upward and disengage the two regulator bolts from the door.
10. Remove the window regulator through the opening in the door and disconnect the door wire harness (4).
Manual
REMOVAL