RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo (2008)
1. Install the window regulator (5) through the opening in the door (1).
2. Engage the two regulator bolts (6) to the door.
3. Install the two bolts (2) that secure the window regulator to the door and tighten all four regulator bolts to 10 Nm (89 in. lbs.).
4. Position the regulator stabilizer (4) onto the door and install the two nuts (3). Tighten the nuts to 10 Nm (89 in. lbs.).
5. Raise the window regulator (3) to the position shown and remove the manual window crank.
6. Support the door glass (2) and remove the wooden wedge or equivalent.
7. Position the door glass to the window regulator and install the two nuts (1) that secure the door glass to the window regulator through the sight
window (4) and the speaker opening (5). Tighten the nuts to 10 Nm (89 in. lbs.).
8. Install the waterdam See: Rear Door Panel/Service and Repair/Rear Door Waterdam/Installation .
9. Install the inner belt molding See: Rear Door Window Glass/Rear Door Window Glass Weatherstrip/Service and Repair/Rear Door Inner Belt
Molding/Installation .
