RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo (2008)
2. Install the pulley (2) on the pump (1) using (OTC(R) 7771) power steering pulley installation tool or equivalent (3) making sure it is flush with the
end of the shaft. Ensure the tool and pulley remain aligned with the pump shaft.
3. Install the power steering pump assembly, See: Power Steering Pump - Installation .
4. Run engine until warm (5 min.) and note any belt chirp. If chirp exists, move pulley outward approximately 0.5 mm (0.020 in.). If noise increases,
press on 1.0 mm (0.040 in.). Be careful that pulley does not contact mounting bolts.
