RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo (2008)
VALVE BODY INSTALLATION
NOTE: Install valve body on a slight angle and verify that the shaft on the manual shift valve and the roller detent spring (11) has properly
engaged the manual valve lever (13).
NOTE: Bolts with conical washers are not reusable.
4. Install the valve body onto the transmission case.
5. Install and then tighten the bolts in the following order:
a. Install bolts (2*) and (3*) and tighten by hand in order to hold valve body onto transmission case.
b. Install detent spring, (10), (11) and bolts (5), (8) with wave washer (9), and tighten by hand.
c. Install clamp (12) along with bolt (15) on the prescribed position and tighten by hand.
d. Install bolts (15), (4), (6) and (7) on each correct position and tighten by hand.
e. Tighten bolts (2*) and (3*) to 10 Nm ( 88 in.lbs.).
f.
Tighten bolts (4), (5), (6),(7), (15) to 10 Nm ( 88 in.lbs.) and (8) to 5.5 Nm (49 in. lbs.).
