RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo (2008)
1. With axle in 2WD remove front propeller shaft and left half shaft.
2. Rotate pinion gear three or four times and verify pinion rotates smoothly.
3. Record pinion torque to rotate with an inch pound torque wrench (2), for installation reference.
4. Position Holder 6719 against the companion flange (1) and install a four bolts and washers into the threaded holes and tighten the bolts.
5. Remove pinion nut.
6. Mark a line across the pinion shaft and flange for installation reference.
7. Remove companion flange with (1) Remover C-452 (2).
8. Remove pinion seal with a seal puller.
Installation
INSTALLATION
1. Apply a light coating of gear lubricant on the lip of pinion seal.
