RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo (2008)
1. Lubricate bearing bore and seal lip with gear lubricant.
2. Install axle shaft with new snap ring and verify axle shaft snap ring is seated in side gear.
3. Install o-ring (1) and snap ring (2) on axle shaft (3).
4. Install half shaft.
5. Verify differential fluid level and add fluid if necessary.
Removal
REMOVAL
1. With the vehicle in neutral, position vehicle on hoist.
2. Remove brake caliper, rotor and ABS wheel speed sensor if equipped.
3. Remove axle shaft (2) cotter pin (3), hub nut (1) and washer.
