RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo (2008)
2. Remove rear propeller shaft. See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Removal and
Replacement
3. Using a suitable pry tool or slide-hammer mounted screw, remove the extension housing seal.
Installation
INSTALLATION
1. Clean fluid residue from sealing surface and inspect for defects.
2. Using Seal Installer D-163 (2) and Universal Handle C-4171 (1), install seal in extension housing.
3. Install propeller shaft. See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Removal and Replacement
4. Verify proper transfer case fluid level.
5. Lower vehicle.
Removal
REMOVAL
1. Remove the front propeller shaft See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Removal and
Replacement .
2. Remove the front propeller shaft seal boot (1) retaining clamp (2).
3. Remove the front propeller shaft seal boot (1).