RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Crankshaft Main Bearing Seal: Service and Repair
Removal
REMOVAL
1. Disconnect the battery negative cables.
2. Remove the transmission and transfer case (if equipped).
3. Remove the clutch cover and disc (if manual transmission equipped).
4. Remove the flywheel or converter drive plate.
5. Remove the flywheel adapter plate.
6. Drill holes 180° apart into the seal. Be careful not to contact the drill against the crankshaft.
7. Install #10 sheet metal screws (1) in the drilled holes and remove the rear seal with a slide hammer (4).
