RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Exhaust Manifold: Removal and Replacement
Removal
REMOVAL
1. Disconnect the battery negative cables.
2. Drain the coolant. See: Cooling System/Service and Repair
3. Raise vehicle on hoist.
4. Remove the EGR cooler. See: Powertrain Management/Emission Control Systems/Exhaust Gas Recirculation/EGR Cooler/Service and
Repair/Removal and Replacement
5. Remove the air filter housing. See: Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and Repair
6. Remove the air filter inlet hose from the turbo inlet.
7. Remove the delta-P line bracket capscrew nuts and remove the delta-P line from the exhaust manifold and thermostat housing.
8. Remove the heat shield and noise panel (if equipped) from the exhaust manifold.
9. Remove the turbocharger. See: Powertrain Management/Fuel Delivery and Air Induction/Turbocharger/Service and Repair/Removal and
Replacement
10. Remove the two (2) rear exhaust manifold capscrew lock plates.
11. Remove the Cab Heater tubing/bracket from the exhaust manifold stud.
12. Remove the exhaust manifold.
Installation
INSTALLATION