RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Dome Lamp Bulb: Service and Repair
Removal
Dual Lamp - Bulb
DUAL LAMP - BULB
1. Disconnect and isolate the battery negative cable.
2. Remove the dome lamp (2) from the headliner.
3. With the lamp lens (1) in the open position, carefully unsnap the bulb (3) from the two bulb holders within the dome lamp housing.
Single Lamp - Bulb
SINGLE LAMP - BULB
NOTE: There are two types of single lamp dome lamps available in this vehicle: one with a switch that is activated by depressing the lamp lens, and one
without a switch. The bulb types and service procedures are identical for both of these lamps.
1. Disconnect and isolate the battery negative cable.
2. Insert the tip of a small flat-bladed screwdriver into the notch on one side of the dome lamp between the lens (4) and the lamp housing (1).
3. Gently pry the notched edge of the lens downward until it unsnaps from the housing.
4. Swing the notched end of the lens downward far enough to access the bulb (3).
5. Carefully unsnap the bulb from the two bulb holders within the dome lamp housing.
