RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
NOTE:
If this flash process is interrupted/aborted, the flash should be restarted.
1. Reprogram the ECM with the latest software. Follow the detailed service procedures available in DealerCONNECT/TechCONNECT, Refer To
Group 8 - Electrical> Electronic Control Modules - Service Information> Module - Powertrain Control> Standard Procedures> PCM/ECM
Programming - Diesel. After ECM reprogramming, the following must be performed:
a. Clear any DTC's that may have been set in other modules due to reprogramming. The wiTECH application will automatically present all DTCs
after the flash and allow the tech to clear them.
2. Type the necessary information on the "Authorized Modification Label" and attach it near the VECI label.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.