RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
PARTS REQUIRED:
SPECIAL TOOLS / EQUIPMENT REQUIRED:
REPAIR PROCEDURE:
NOTE:
If this flash process is interrupted/aborted, the flash should be restarted.
1. Verify the ECM is at the latest software level. Is the ECM at the latest software level?
a. Yes - Proceed to Step # 3.
b. No - Proceed to Step # 2.
2. Reprogram the ECM with the latest software. Follow the detailed service procedures available in DealerCONNECT/TechCONNECT, Refer To
Group 28 - DTC-Based Diagnostics> MODULE, Engine Control (ECM), 6.7L> Standard Procedure> PCM/ECM /TCM Programming.
3. Reprogram the TCM with the latest software. Follow the detailed service procedures available in DealerCONNECT/TechCONNECT, Refer To
Group 28 - DTC-Based Diagnostics> MODULE, Engine Control (ECM), 6.7L> Standard Procedure> PCM/ECM /TCM Programming. After
ECM/TCM reprogramming, the following must be performed:
a. Clear any DTC's that may have been set in other modules due to reprogramming. The wiTECH application will automatically present all DTC's
after the flash and allow the tech to clear them.
4. Type the necessary information on the "Authorized Modification Label" and attach it near the VECI label.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
