RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
10. Remove the rear center seat belt and retractor unit from the vehicle.
Rear Outboard - Mega Cab
REAR OUTBOARD - MEGA CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
NOTE: The only component of this seat belt and retractor unit that is available for individual service replacement is the plastic web stop button that
prevents the latch plate from falling to the floor while in the stored position. Refer to the instructions supplied with the service kit for the proper web stop
button replacement procedures.
NOTE: All seat belt retractors except the driver side front retractor include a switchable automatic locking mechanism.
1. Remove the rear seat from the vehicle.
2. Remove the screw (6) that secures the seat belt lower anchor (7) to the base of the inner C-pillar.
3. Unsnap the trim cover (4) from the front seat belt turning loop (3) and discard.
4. Remove the screw (5) that secures the seat belt turning loop to the height adjuster (1) on the upper C-pillar.
5. Remove the seat belt turning loop from the height adjuster.
6. Remove the upper trim (2) from the inside of the C-pillar.
