RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
2. Install and tighten the screw (3) that secures the lower retractor bracket to the C-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
3. Position the belt web guide (5) to the B-pillar and use hand pressure to press it firmly and evenly until the two clips that secure it snap into place.
4. Reinstall the lower trim (2) onto the inside of the C-pillar. Be certain that the turning loop (1) can be accessed from the face of the lower trim after
the seat belt webbing is inserted through the slot in the trim.
5. Reinstall the upper trim (2) onto the inside of the C-pillar.
6. Position the seat belt turning loop (3) onto the height adjuster (1) on the upper C-pillar.
7. Install and tighten the screw (5) that secures the turning loop to the height adjuster. Tighten the screw to 39 Nm (29 ft. lbs.).
8. Engage the upper edge of a new trim cover (4) over the top of the turning loop. Then squeeze the lower end of the trim cover and the turning loop
together firmly and evenly until the engagement tabs of the trim cover snap into the slots of the turning loop.
9. Position the seat belt lower anchor (7) to the mounting hole at the base of the C-pillar.
10. Install and tighten the screw (6) that secures the lower anchor to the C-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
11. Reinstall the rear seat into the vehicle.
Rear Outboard - Quad Cab
REAR OUTBOARD - QUAD CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
NOTE: The only component of this seat belt and retractor unit that is available for individual service replacement is the plastic web stop button that
prevents the latch plate from falling to the floor while in the stored position. Refer to the instructions supplied with the service kit for the proper web stop
button replacement procedures.
NOTE: All seat belt retractors except the driver side front retractor include a switchable automatic locking mechanism.
