RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
1. Inspect the piston teflon seals for damage. Replace if needed.
NOTE: To replace the teflon seals, use a pick to remove the teflon O-ring and the rubber O-ring underneath. Install a new rubber O-ring
in the piston seal grove and a new teflon O-ring over the top of it.
2. Install the valve into the valve housing (1).
3. Thread the retainer ring into the valve housing (1). Tighten to 97 Nm (72 ft. lbs.).
NOTE: It is very important to make sure to compensate for the added length of the torque wrench when torquing to proper
specifications.
4. Install the retainer ring set screw. Tighten to 2.26 Nm (20 in. lbs.)
5. Clean the steering gear housing.
CAUTION: Valve assembly must be centered to the housing (1).
6. Install the valve assembly (2) into the steering gear. Tighten the new bolts to 54 Nm (40 ft. lbs.)
7. Install the input shaft seal protector 8986 (2).
