RAM 3500 Van V8-360 5.9L Magnum (1995)
Valve Body: Service and Repair
42RE/42RH/46RH/47RH 4-Speed
1. Raise and support vehicle with transmission in Neutral position.
2. Drain fluid and remove oil pan.
3. Loosen clamp bolts, then remove throttle and manual valve levers from manual lever shaft.
4. Remove neutral switch, then filter.
5. Disconnect lock-up solenoid electrical connector, then push connector through case.
6. Remove valve body attaching screws, then lower valve body enough to remove accumulator piston and piston springs.
7. Disengage park rod by pushing valve body forward.
8. Remove manual lever shaft and solenoid connector from case. Lower valve body, rotate it away from case, then pull park rod out of sprag and
remove valve body.
9. Reverse procedure to install, noting the following:
a. Ensure neutral switch is not installed prior to valve body, as valve body cannot be installed when switch is in place.
b. Place valve body manual lever in low position when installing park rod into sprag.
c. Tighten valve body attaching bolts and oil pan bolts to specifications.
d. Fill transmission with MOPAR ATF+4 Type 9602 , or equivalent.
