RAM 3500 Van V8-360 5.9L VIN 5 Magnum (1998)
Cruise Control Servo: Service and Repair
The speed control servo is bolted to the radiator/ grille support under the right headlamp.
REMOVAL
1. Disconnect negative battery cable at battery.
2. Remove engine cover.
4. Disconnect servo cable at throttle body Refer to Servo Cable Replacement.
5. Remove right headlamp assembly. Refer to Lighting and Horns/ Headlamp Bulb Replacement Lamps for procedures.
Speed Control Servo Location
6. Disconnect vacuum hose (line) at servo.
7. Disconnect electrical connector at servo.
8. Remove 2 servo mounting bracket bolts.
Servo Cable Clip Remove/Install - Typical
9. Remove 2 mounting nuts holding servo cable sleeve to bracket.
10. Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip and remove clip. Note: The servo
mounting bracket displayed in is a typical bracket and may/may not be applicable to this model vehicle.
11. Remove servo from mounting bracket.
INSTALLATION
1. Position servo to mounting bracket.
2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip.
3. Insert servo mounting studs through holes in servo mounting bracket.
4. Install servo-to-servo bracket mounting nuts and tighten to 8.5 N.m (75 in. lbs.) torque.