RAM 3500 Van V8-360 5.9L VIN 5 Magnum (1998)
Cruise Control Switch: Service and Repair
REMOVAL
WARNING: BEFORE BEGINNING ANY AIRBAG SYSTEM COMPONENT REMOVAL OR INSTALLATION, REMOVE AND ISOLATE
THE NEGATIVE (-) CABLE FROM THE BATTERY. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. THEN
WAIT TWO MINUTES FOR SYSTEM CAPACITOR TO DISCHARGE BEFORE FURTHER SYSTEM SERVICE. FAILURE TO DO THIS
COULD RESULT IN ACCIDENTAL AIR BAG DEPLOYMENT AND POSSIBLE INJURY.
1. Disconnect and isolate negative battery cable.
2. Remove airbag module. Refer to airbags
Speed Control Switches
3. Remove switch-to-steering wheel mounting screws.
4. Remove switch.
5. Remove electrical connector at switch.
INSTALLATION
1. Install electrical connector to switch.
2. Install switch and mounting screws.
3. Tighten screws to 1.5 N.m (14 in. lbs.) torque.
4. Install airbag module. Refer to airbags for procedures.
5. Connect negative battery cable.