RAM 3500 Van V8-360 5.9L VIN 5 Magnum (1998)
7. To align the bearing cap, use cap slot, alignment dowel and cap bolts. DO NOT remove excess material after assembly. DO NOT strike rear cap
more than 2 times for proper engagement.
8. Clean and oil all cap bolts. Install all main bearing caps. Install all cap bolts and alternately tighten to 115 Nm (85 ft. lbs.) torque.
9. Install oil pump.
10. Apply Mopar Silicone Rubber Adhesive Sealant, or equivalent, at bearing cap to block joint to provide cap to block and oil pan sealing (refer to
Oil Pan Replacement).
11. Install new front crankshaft oil seal.
12. Immediately install the oil pan.
