RAM 3500 Van V8-360 5.9L VIN 5 Magnum (1998)
Circuit Breaker: Service and Repair
REMOVAL AND INSTALLATION
1. Disconnect and isolate the battery negative cable.
2. Remove the end cap from the driver side end of the instrument panel. Refer to Instrument Panel, Gauges and Warning Indicators/Instrument
Panel/Instrument Panel End Cap.
Junction Block
3. Unplug the circuit breaker from the junction block.
4. Install the circuit breaker by aligning its terminals with the cavities in the junction block and pushing the circuit breaker firmly into place.
5. Connect the battery negative cable.
6. Test the circuit breaker operation.
7. Reinstall the end cap on the instrument panel. Refer to Instrument Panel, Gauges and Warning Indicators/Instrument Panel/Instrument Panel End
Cap.