RAM 3500 Van V8-360 5.9L VIN 5 Magnum (1998)
Fig 25 Fuel Tube And Clamp -- Typical
4. Gently cut the old fuel tube (line) clamp (Fig. 25) taking care not to damage the plastic fuel tube. Remove and discard the old fuel tube clamp.
5. Remove the plastic fuel tube from the filter/regulator gently pulling downward. Remove filter/regulator from fuel pump module.
Fig 26 Tightening Fuel Tube Clamp -- Typical
INSTALLATION
1. Install a new clamp over the plastic fuel tube.
2. Install filter/regulator to fuel tube.
-
Rotate the filter/regulator in the fuel tube (line) (Fig. 26) until it is pointed to the drivers side of vehicle (Fig. 22).
3. Tighten line clamp to fuel line using special Hose Clamp Pliers number C-4124 or equivalent (Fig. 26).
-
Do not use conventional side cutters to tighten this type of clamp.
4. Slide the convoluted plastic tube (cover) up to the bottom of filter/regulator and install snap ring (Fig. 24).
5. Press the filter/regulator (by hand) into the rubber grommet.
-
The assembly should be pointed to the drivers side of vehicle (Fig. 22 ).
6. Install fuel tank.
-
Refer to Fuel Tank Removal/Installation.
7. Check for fuel leaks.